English Deutsch Français Italiano
Previous page Next page Machinal science is over all others of great usefulness, as by it all moving bodies perform their operations.(Leonardo da Vinci)
SINGLE STAGE SUPPORT ELEMENTS (Low Raise)
TYPE FL AIR PADS

Type FL air pads shall give a very good resistance to wear, a low friction (approximately load/1000) and a low air consumption for a well fitted installation. They may be used with both air or water.

They are preferred for almost constant high loads and for special applications.

Type S (standard) has a maximum bearing capacity from 500 to 15,000 kg with a maximum air pressure of 1 bar (100 kPa). Type HP (high pressure) has a doubled bearing capacity with a maximum air pressure of 2 bar (200 kPa). Type SHP has a bearing capacity 3.5 times higher with a maximum pressure of 3.5 bar (maximum capacity per element 50,000 kg).

Section Pad
Type Capacity Dimensions (mm) Air consump- Fitting
kg L l H1 H2 A(raise) tion (Nl/1')
FL 25 S 300 250 27 39 5-8 80-150 1/4"
FL 30 S 500 300 27 39 6-10 100-200 1/4"
FL 40 S 1,000 400 27 39 9-16 130-250 1/4"
FL 50 S 1,800 500 25 40 9-16 240-450 1/2"
FL 70 S 3,000 700 25 40 12-25 400-750 1/2"
FL 90 S 6,000 900 25 65 19-32 500-1000 3/4"
FL 1205 S 10,000 1250 25 65 19-51 800-1200 3/4"
FL 1218 S 15,000 1200 1800 25 65 19-51 1200-1500 1"
FL 125 HP 20,000 1250 25 65 19-51 1200-1500 1"
FL 1218 HP 30,000 1200 1800 25 65 19-51 1500-1800 1"
FL 125 SHP 35,000 1250 25 65 19-51 1500-1800 1"
FL 1218 SHP 50,000 1200 1800 25 65 19-51 1800-2400 1"
· Capacity will vary with floor conditions.
· Air consumption and raise are a function of floor conditions, of load and of air pressure.
· Ask for other dimensions.

S01F

PREXCO srl - Via Primo Maggio, 10 - I-46051 SAN GIORGIO BIGARELLO MN - IT01264000207 - info@prexco.it